Water Transfer / Applied before clear coating
Water transfer involves applying a thin ink layer onto the object. The resulting sticker mark becomes invisible after the coating process, imparting a high-quality texture to the product.
Water Transfer is divided into the following products based on the different substrates and requirements of the painting process:
-
HRST (Heat Resistant Solvent Transfer)：Liquid coated bike
-
HRST-P(Solvent Transfer for Powder Coating)：Powder coated bike
-
HRWT(Heat Resistant Water Transfer)：Helmets, phone cases, plastics, bike frames
-
HRNT(Heat Resistant Non-Film Transfer) ：High-end products, carbon fiber frames, rackets, golf clubs, plastics, glasses, fishing poles, woods, curved surfaces, welding area
Water Transfer Products
Operating Process：
1. Remove protection sheet and soak the decal in the warm water(about 20~40℃) for 5 to 10 seconds.
2. Position the transfer decal on the object gently.
3. Use a rubber squeegee to press out the water and air, then remove liner sheet.
4. Wash out the glue remaining on the decal and its surroundings using clean water and wet cloth. Dry the area with dry cloth.
5. Dry the product in the oven at 70℃~100℃ for 15~20min. This process is to dry out the decal.
6. Do the clear coating after the product cools down.
2. Position the transfer decal on the object gently.
3. Use a rubber squeegee to press out the water and air, then remove liner sheet.
4. Wash out the glue remaining on the decal and its surroundings using clean water and wet cloth. Dry the area with dry cloth.
5. Dry the product in the oven at 70℃~100℃ for 15~20min. This process is to dry out the decal.
6. Do the clear coating after the product cools down.
